The SFP transceiver is high performance, cost effective modules. It is designed for 100BASE-FX applications of 10km with SMF. The transceiver consists of two sections: The standard SFP part and the PHY part built with SGMII interface.
The optical output can be disabled by a TTL logic high-level input of Tx Disable, and the system also can disable the module via I2C. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner. The system can also get the LOS(or Link)/Disable/Fault information via I2C register access.. The host equipment can access this information via the 2-wire serial CMOS EEPROM protocol. For further information, please refer to SFP Multi-Source Agreement (MSA).
|Package (Form Factor)||SGMII SFP|
|Data Rate (typical)||125 Mb/s|
|Distance||10km For SMF|
|Receiver||PIN photo detector|
|TX Output Power (dBm)||-18~-8|
|RX Sensitivity (dBm)||-31|
|Low/High Case Temperature||0°C~70°C|
|Voltage Supply (typical)||3.3v|